I finally got around to setting up my N42C today.
I installed the included m.2 SSD card, but forgot that I did so when I later read the directions, which state to NOT install the card before activating W10 Pro AND THEN disabling eMMC Support.
I happily plugged along, installing and modifying W10 to suit me. Everything looked splendid.
Then I realized that I'd already installed the card! Well, it's too late now, I thought.
So I disabled the eMMC Support and rebooted. The boot screen reported an error about not finding Device Mapping Table.
I took the m.2 card out and rebooted. This time a different error: cannot find required map name.
I reinstalled the card and rebooted, but re-enabled the eMMC support. A whole new list of errors appeared re: PCIroot and harddisk.
I removed the m.2 card and tried rebooting with eMMC enabled, but get the device mapping table error.
I know zero about BIOS. How do I save this situation?
I installed the included m.2 SSD card, but forgot that I did so when I later read the directions, which state to NOT install the card before activating W10 Pro AND THEN disabling eMMC Support.
I happily plugged along, installing and modifying W10 to suit me. Everything looked splendid.
Then I realized that I'd already installed the card! Well, it's too late now, I thought.
So I disabled the eMMC Support and rebooted. The boot screen reported an error about not finding Device Mapping Table.
I took the m.2 card out and rebooted. This time a different error: cannot find required map name.
I reinstalled the card and rebooted, but re-enabled the eMMC support. A whole new list of errors appeared re: PCIroot and harddisk.
I removed the m.2 card and tried rebooting with eMMC enabled, but get the device mapping table error.
I know zero about BIOS. How do I save this situation?